Bomag BW 100 AD-5, Operating & Maintenance Instructions

Page: 95 / 212

4. Set the throttle lever to position “MAX II”.
5. Before leaving the machine, make sure
that nobody enters the driver’s stand.
6. Open the engine hood.
Ä
Chapter 8.2.2.1
„Open and secure the engine
hood“ on page 140
7. Check on the left hand side of the machine
if the pin of the maintenance indicator has
popped out.
8. Check the maintenance indicator at max-
imum engine speed.
9. If the pin is visible, press it in.
ð
Should the pin remain pressed in, the
hydraulic oil filter is in good condition.
10. If the pin pops out, replace the hydraulic oil
filter
Ä
Chapter 8.10.5 „Replacing the
hydraulic oil filter“ on page 166 .
11. Close the engine hood.
Ä
Chapter 8.2.2.2
„Closing the engine hood“ on page 140
12. Shift the throttle lever to position “MIN” (idle
speed).
13.
NOTICE!
Danger of engine damage!
– Do not shut down the engine
all of a sudden from full load
speed, but let it idle for about
two minutes.
Turn the ignition key to position “0”.
MIN.
MAX II
MAX I
B-880-0160
Fig. 62
B-880-0194
Fig. 63
B-ELE-0069
Fig. 64
Checks prior to start up – Checking the hydraulic oil filter
BW 100 AD-5 95