GPS
I/O&RS485&RS232
AV-OUT
After wiring and parameters setting of PTZ, users can only use remote to control PTZ after
selecting the channel access to PTZ, for example, if PTZ connects through channel 2, then
you need to switch to channel 2 maximize on the monitor interface to control it.
Setup steps
Firstly, select the PTZ protocol: divided into PELCO-D and PELCO-P protocol, most of peoplewill choose
PELCO-D
Secondly, set the baud rate: there are four options 1200/2400/4800/9600 which must be corresponded with
the baud rate on PTZ
Thirdly, set the address code: directly input the address value corresponding with PTZ setting, corresponding
is required. Generally the defaulted PTZ address code is 1, PTZ address code has adjustable DIP, it is needed
to set different address codes to identify when there is many PTZs.
Fourthly, wiring: Connect control wire 485 on the PTZ to the RS485-A positive pole, connect the other one
to the RS485-B negative pole.
The power input of the PTZ
Video
First way: the remote control PTZ wiring
Second way: with a three-dimensional
keyboard control PTZ
The power input of the PTZ
Video line
RS485
Connection Key
3D Key
Fifthly, there are three ways of wiring, the first way is connecting the 485 control wire to the wire 485A and
485B on host, connecting the video cable to the host video input and then provide power to PTZ; this kind
of wiring needs to set the MDVR host data be corresponding to PTZ data, and then use the remote controller
or platform to remotely control PTZ.
The second way, the head of the 485 control wire directly connect to the three-dimensional control keyboard,
do not need to connect the MDVR host, the video cable connects to the host video input, separately power
supply to the PTZ and three-dimensional keyboard, and then set the keyboard parameters to be corresponding
with PTZ. This wiring way is the most practical one, because it uses three-dimensional keyboard to control
PTZ, which is faster, easier and more practical. It is recommended to use this way to install PTZ
The third way is to connect to both car host and three-dimensional control keyboard, so that both can be
controlled and platform remote can also be controlled.
GPS
Note
