10
FIGURE 2
WARNING! Armrests are provided for comfort and should be used as armrests only. The armrests are not
designed to carry the full weight of the user. Never place more than fifteen (15) lbs of force on the armrests.
Failure to follow these instructions may result in serious injury or death!
STEP 2.
Slide the Left and Right Shooting Rail Stops over the front of the Armrests
and secure using two (2) 1/4" Delta Bolts (M). Next insert1/4" x 2 1/2" Carriage
Bolts (I) in top hole in rear of Armrest facing outward (Fig. 2)
STEP 3.
Insert the Rear Frame
Support into the Side Frame
aligning holes. Next connect
the Left and Right Backrest
Supports, then attach the as-
sembled Backrest Support to
the Side Frames and Armrests
using two (2) 1/4" x 3 1/4"
Hex Bolts (F), four (4) Nylon
Washers and two (2) Nylock
Nuts.
Note:
the lower holes
are used in the Armrests and
Backrest Support. The bends
of the Backrest are to angle to
the rear. Next attach the front
of the Armrests to the outside
of the Side Frames using two
(2) 1/4" x 2 1/4" Hex Bolts (E) ,
four (4) Nylon Washers and
two (2) Nylock Nuts. (Fig. 3)
Armrest
Armrest
Rear Frame
Support
Right Side
Frame
Left Side
Frame
Left Backrest
Support
Right Backrest
Support
FIGURE 3
This instruction manual complies with ASTM F2123 Standard Practice for Treestand Instruction.
READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.