307
304
128
147
306
62
62
318
147
147
147
154
72
84
301
303
13
94
95
308
142
72
72
154
169
146
146
169
169
64
146
146
169
64
147
302
96
10
1
CABLE COLUMN BASE FRAME ASSEMBLY
22
1. Attach two 50mm SQ. Plugs (64) to Cable Column Weight Stack Base (301). Attach Cable
Column Weight Stack Base (301) to Base Frame (1), using two 1/2" X 1-1/4" Hex Threaded Bolt
(169) and two 1/2" Washers (146).
2. Attach Front Stabilizer (303) to Weight Stack Base (301), using two 3/8" X 3-1/8" Hex Bolts
(318), four 3/8" Washers (147) and two 3/8" Nuts (154). Attach two 50mm SQ. Caps (62) onto
both ends of Front Stabilizer (303).
3. Insert two Plastic Guide Rod Holders (72) into Weight Stack Base (301). Slide two Rubber
Donuts (84) onto one end of each Guide Rod (13), then insert Guide Rod (13) into the Plastic
Guide Holders (72) in the Weight Stack Base (301).
4. Slide each 10 LB Plate (96) over Guide Rod (13). Make certain that each plate is oriented with
selector hole on bottom and facing forward. Attach Top Plate (95) to Selector Rod (94) using
Top Plate Bolt (142). Slide Top Plate (95) and Selector Rod (94) over Guide Rods (13). Insert
Plastic Guide Rod Holder (72) into Top Guide Rod Retainer (302), and then slide Top Guide Rod
Retainer (302) over top of Guide Rods (13).
5. Attach Top Guide Rod Retainer (302) to Top Frame (10), using two 1/2" X 1-1/4" Hex Thread
Bolt (169) and two 1/2" Washers (146).
6. Slide Cable Height Adjuster (304) onto Chromed Upright (306) and then insert the Hand Holder
(307) into the top of Chromed Upright (306) as shown. Attach to Guide Rod Retainer (302),
using two 3/8" X 3" Hex Bolts (128), four 3/8" Washers (147) and two 3/8" Nylon Nuts (154).