BR2998
Page 12
Assembly STEP 5
Align and attach the
Pulse Handle Bar (#08)
to the bracket on the
Center Post (#02)
, secure them together by using two
Bolts (#22)
.
Clip the
Pulse Handle Bar Cover (#42)
onto the Center of the
Pulse
Handle Bar (#08)
.
Remove the
Screws (#26)
that are pre-assembled on back of the
Monitor (#56)
and set them aside as they will be used shortly in this
step.
Connect the
Monitor Wire (Upper) (#58)
to the Wire on the
Monitor
(#56)
and connect the
Pulse Sensor Wire (#57)
to the back of the
Monitor (#56)
.
Secure the
Monitor (#56)
to the bracket of the
Center Post (#02)
by
using four
Screws (#26)
that were previously removed.
Attach the
Water Bottle Holder (#61)
to the
Center Post (#02)
,
secure them together by using two
Screws (#25)
.
Hardware Required
Note:
HAND PULSE SIGNAL
After assembly is completed, if the computer is not picking up your
hand pulse signal (or you are getting inaccurate readings), please refer
to our “Troubleshooting” section to resolve the issue.
#22.Bolt (M8x30 mm)
[2 pieces]
#25.Screw (M5x15 mm)
[2 pieces]
#26. Screw (M5x12 mm)
[4 pieces]
Summary of Contents for BR2998
