BRT7989/7200
Page 24
Computer Operation
3. Pulse Recovery Test
The pulse recovery test is to compare your heart rate before and after exercise. It is target to
determine your heart strength via the measuring. Please do the test as below:
A. Both your hands hold the pulse sensor or via wireless transmitter belt to test the pulse(if applicable), the computer will display your
current pulse value.
B. Press RECOVERY to enter the pulse recovery test and the computer program will enter the stop status.(See fig 41)
C. Keep pulse detecting.
D. Time will count down from 60 seconds to 0 second.
E. When time reaches 0, the test result (F1-F6) appears on the display.
F1 = Excellent F2 = Good F3 = Fair F4 = below average F5 = No Good F6 = Poor (See fig 42)
F. If the computer does not detect your current heart rate first, pressing RECOVERY will not enter into pulse recovery test.
During the pulse recovery test, press RECOVERY to exit the test and return to the stop status.
Speed (M/H)
showing your current speed. Range: 0.0~99.9 (M/H)
RPM
showing the current rotate per minute. Range : 0（999
TIME:
the accumulative exercise time, range : 0:00~99M59S. The preset time range is 5:00~99M00S.
The computer will start to count down from preset time to 0:00 with average time for each resistance level.
When it reaches to zero, the program will stop and computer alarm. If you do not preset the time, it will run
with one minute decrement each resistance level
DIST
the exercise accumulative distance. Range : 0.0~99.9~ 999 (MILE) the preset distance range :1.0~99.0~999.
When the distance reaches 0, the program will stop and the computer will alarm
CALORIE
the exercise accumulative calories burnt. Range : 0.0~99.9~999 the preset calories range :10.0~90.0~990.
When the calorie reaches 0, the program will stop and the computer will alarm
PULSE
showing the exercise heart rate value.
Range: 30~240 bpm (beat per minute)
RESISTANCE
LEVEL
showing resistance level.
Range:1~16
WATT
show the exercise watt
4. Pulse Measurement
Please place both your palms on the contact pads and the computer will show your current heart
beat rate in beats per minute (BPM) on the LCD after 3~4 seconds. During the measurement, heart
icon will flash with simulative ECG showing.
fig 41
fig 42
REMARK:
During the process of pulse measurement, because of the contact jamming, the
measurement value may not be stable when start, then it will return to normal level. The
measurement value cannot be regarded as the basis of medical treatment.
NOTE:
If the computer is also equipped with wireless heart rate measuring via the transmitter
belt, and with hand pulse function, the hand-measurement-signal-detecting is preferred.
ST OP
ST OP
PULSE
TIME
Specifications
