Body Champ BRB5688, Owner'S Manual

Page: 12 / 24

BRB5688 Page 10
Assembly STEP 4
A.) Attach the Front Handle Bar (#08) to the Center Post (#04) . Insert
two Bolts (#20) through the Front Handle Bar (#08) to the Center
Post (#04) and tighten.
B.) Remove the four Screws (#21) that are pre-assembled on the
back of the Monitor (#39) and set them aside. Attach the wire of
the Monitor (#39) to the Monitor Wire (Middle) (#43) . Connect Hand
Pulse (#40) wire into the power plug hole on the back of the Monitor
(#39) as shown in the detail diagram. Tucking in the wires carefully
to avoid pinching them and then attach the wire of the Monitor (#39)
to the bracket of Center Post (#04) . Secure them together using four
Screws (#21) .
C.) Remove the two Screws (#47) that are pre-assembled on the
Center Post (#04) and set them aside. Attach the Water Bottle Hold-
er (#48) to the Center Post (#04) and secure them together by using
two Screws (#47) .
Note:
HAND PULSE SIGNAL
After assembly is completed, if the computer is not picking up your
hand pulse signal (or you are getting inaccurate readings), please refer
to our “Troubleshooting” section to resolve the issue.
Hardware Required
#20 Bolt (M8x30mm)
[2 pieces]
#21 Screw (M5x12mm)
[4 pieces pre-assembled]
#47 Screw (M5x15mm)
[2 pieces pre-assembled]