11
4. Insert the Voyager 64 in the slot that you
have selected, so that the edge connector
on the bottom of the board mates with the
socket on the motherboard. Press firmly on
the board and ensure that it seats properly
into the slot. Secure the board with the
screw you removed in step 3.
5. Slide the computer cover back over the
chassis, taking care not to let it catch on
the disk drive or power cables. Once the
cover is in place, replace all the screws that
you removed earlier.
6. Re-attach all cables and power cords to
their original positions.
7. Attach the appropriate monitor cable to the
Voyager 64.
8. Power up your system.
Physical installation is complete.
If you wish to enhance your display, turn to
the Display Driver section on page 18.
NOTE: Drivers are not required if the board
is used under DOS and Windows in standard
VGA modes. Drivers are required to run
high-resolution applications under DOS and
Windows.
EXPRESS Install
