58
WEBGLIDER-460
W1 The CONNECT message reports the port speed.
If S95 is 0 CARRIER and PROTOCOL
messages are enabled. The CARRIER speed is the
ISDN B-channel speed.
W2 The CONNECT message reports the link speed.
If S95 is 0 the extended negotiation messages are disabled.
See also:
S95
X Result code and call progress messages
Syntax:
ATX[0|1|2|3|4]
Description:
Configuration of response codes sent to DTE to
report call progress.
X
Same as X4
X0,X1 Sends NO CARRIER when destination is busy.
Sends NO CARRIER when no B-channel is available or
no link to central office (C.O.) (default).
X2 Sends NO CARRIER when destination is busy
Sends NO Dial tone when no
B-channel or no link to
C.O.
X3 Sends BUSY when destination is busy
Sends NO CARRIER when no B-channel or no link to
C.O.
X4 Sends BUSY when destination is busy
Sends NO Dial tone when no B-channel or no link to
C.O.
&B B-channel Profile selection
Syntax:
AT&B[1|2|3|4]
Description:
This command selects the current B-channel
profile. The B-channel profile controls data compression and rate
aggregation. Data compression uses the V.42bis standard and
TU120AE.PM5
2/16/96, 11:05 AM
58
Summary of Contents for Webglider-460
