8.4.7
iL Central Monitoring System
The iL Central Monitoring System allows you to network together all of the iL systems in your
installation, and to use a PC to centrally monitor the iL systems. Contact your supplier or BOC
Edwards if you want to network your iL systems.
8.4.8
iL600 Pressure Control Kit (sensor configured iL systems)
Fit an iL600 Pressure Control Kit to an iL600 system to enable the LCMB pump to be
automatically started at a preset inlet pressure. Note that you cannot fit an Active Gauge
Connection Kit accessory (see Section 8.4.4) if you fit an iL Pressure Control Kit.
Accessory
Item Number
iL Pressure Control Kit
A505-40-000
8.4.9
iL Communications Module
Fit a Communications Module accessory to allow your Process Tool or PC-based software to
control and monitor the operation of the iL system through a serial port and/or through a
parallel port, with a small number of digital lines:
•
Serial port communications use the RS232C communications protocol.
•
Parallel port communications implement a sub-set of the iL Tool Interface Module
communications. A single digital control input is used to turn the pump(s) on and off, and
four digital outputs provide pump(s) on, warning and alarm status outputs.
Accessory
Item Number
iL Serial Communications Module
D372-32-000
iL Serial and Parallel Communications Module
D372-35-000
iL Parallel Communications Module
D372-36-000
8.4.10
iL Alternative Nitrogen Connection Kit
Use this kit to reconfigure the iL system to use the alternative nitrogen inlet position (see
Section 3.5)
Accessory
Item Number
Alternative Nitrogen Connection Kit
A505-34-000
8-4
iL Dry Pumping Systems
