Page 84
Mounting the Work.
The DeWalt Rotary Tool should
NEVER
be plugged in
when mounting a work piece.
Always unplug the power
supply when removing or installing router bits. Failure
to follow this simple procedure may result in serious
personal injury.
Danger!
The E3 kit includes clamping hardware. Insert the wing nut onto the
2”
¼
-
20 screw as shown. The screws
will thread into the inserts on the table. The extra clamps can be used as spacers as shown in the
pictures.
If you are new to CNC Routing we offer a quick start guide to walk you thru the software setup and
help get you routing. Please check
BobsCNC.com
for the latest copy.
Tips for cutting with the E3
•
Always unplug the router before changing the bits
•
Do not leave the router unattended.
•
Use a scrap board underneath the work to keep from engraving into the spoil
board.
•
For work such as isolation routing for circuit boards, consider milling a scrap
blank, then use double
-
sided tape to fasten the circuit board.
Summary of Contents for E3
