83
Operator’s Manual Simple AFG Application
Berkeley Nucleonics Corporation
[email protected] | www.berkeleynucleonics.com
2955 Kerner Blvd, San Rafael, CA 94901 | 800-234-7858
Rev 1.1
•
Swipe up or down to select which channel to couple to the Channel 1.
•
ON/OFF button
: enables or disables the channel coupling.
•
Reset
: resets the Ratio and Offset parameters to their default values (1 and 0).
•
Check/Uncheck
: selects/deselects all the available coupling parameters on the selected channel.
•
Check All /Uncheck All
: selects/deselects all the available coupling parameters on all channels (4
channel and 8 channel Models only).
•
Press the parameter checkbox to select/deselect the single coupling parameter.
•
When waveforms have different carrier shapes, only the common parameters will be available
for coupling.
•
When a change of a parameter of Channel 1 causes an out of range error on the coupled
channel, the application will limit the parameters value to the latest valid ones.
•
When a change of the Ratio or Offset value causes an out of range in the coupled channels, the
Ratio and Offset values will be set automatically to the previous valid one.
•
The application may need to recalculate new parameter ranges due to a change in the user
interface (such as carrier waveform type, other waveform parameters, run mode etc.).
In these cases, if the parameter is coupled but the Ratio and the Offset no longer meets the
coupling condition, the parameter coupling will be automatically disabled.
For example, select a Sine Waveform on CH1 and CH2, set a frequency of 1 GHz on CH1 and
coupling frequency with Ratio 1 and Offset 0. The result will be a Sine Waveform on CH2 with a
frequency of 1 GHz.
If you change the carrier waveform of CH2 is changed from Sine to Square, the
