35
Operator’s Manual Simple AFG Application
Berkeley Nucleonics Corporation
[email protected] | www.berkeleynucleonics.com
2955 Kerner Blvd, San Rafael, CA 94901 | 800-234-7858
Rev 1.1
Waveform Parameters Area
This section is composed by two tabs: the
Carrier
tab and the
Secondary
tab.
•
In the
Carrier
tab it is possible to define the Run Mode, of the Carrier Waveform and its
parameters as explained in the relative chapter.
•
In the
Secondary
tab it is possible to define the parameters that describe the
Modulation,
Sweep
and
Burst
. This tab changes title name and functionality depending on the selected Run
Mode. For example, if the Run Mode is Sweep the Secondary tab will take the title name
“Sweep” and the tab page will show the Sweep parameters. The same will happen for
Modulation and Burst modes. In Continuous Run Mode the Secondary tab is not active.
You can touch the parameter area to open the Virtual numeric keypad, edit the parameter value and its
measure unit.
Below there is a description of the keypad items:
