69
Operator’s Manual Simple AFG Application
Berkeley Nucleonics Corporation
[email protected] | www.berkeleynucleonics.com
2955 Kerner Blvd, San Rafael, CA 94901 | 800-234-7858
Rev 1.1
GPIB and USBTMC Connector (optional)
GPIB control
Follow these instructions to setting up the instrument for remote communication using the GPIB
(General Purpose Interface Bus) interface:
•
Connect one side of a GPIB cable to the GPIB port of the Model 685 (on the rear panel), and your
GPIB controller on the other side.
•
In “
Remote Control Panel
“window verify that GPIB Server Status is Enabled; if not, press the
button to enable it.
•
Set the GPIB address. A unique device address must be assigned to each device on the bus. The
default setting for the GPIB configuration is Address [N] 20. If you need to change
the GPIB address set it in Address [N] parameter.
