BMW R 1250RS, Rider'S Manual

Page: 96 / 279

Alarm signal
A DWA alarm can be triggered
by:
motion sensor
switch-on attempt with an un-
authorised vehicle key.
disconnection of the DWA anti-
theft alarm from the motor-
cycle's battery (DWA internal
battery in the anti-theft alarm
provides power - alarm tone
only, the turn indicators do not
flash).
All functions are sustained even
if the internal battery of the DWA
anti-theft alarm system is flat; the
only difference is that an alarm
cannot be triggered if the system
is disconnected from the motor-
cycle's battery.
An alarm lasts for approximately
26 seconds. While an alarm is in
progress an alarm tone sounds
and the turn indicators flash. The
type of alarm tone can be set by
an authorised BMW Motorrad
dealer.
with Keyless Ride
OE
The activated alarm can be abor-
ted at any time by pressing the
1
button on the radio-operated key,
without deactivating the anti-theft
alarm.
If an alarm was triggered while
the motorcycle was unattended,
the rider is notified accordingly
by an alarm tone sounding once
when the ignition is switched on.
The DWA LED then indicates
the reason for the alarm for one
minute.
Light signals issued by the
DWA LED:
Flashes 1x: motion sensor 1
Flashes 2x: motion sensor 2
Flashes 3x: ignition switched
on with unauthorised vehicle
key
Flashes 4x: disconnection of
the anti-theft alarm from the
motorcycle's battery
Flashes 5x: motion sensor 3
DWA Deactivating
Switch on the ignition.
4
94
z Operation