BMR SFU-0303 Series, Manual

Page: 26 / 48

SFU-0303 M a n u a l
E
- 26 -
The following error displays are possible:
Display Error
•
Pulse blocking ! Power stage lock active
•
O v e r l o a d S t o p Overload stop!
•
O v e r t e m p c o n v . Excess Temperature Converter
•
O v e r t e m p s p i n d l e Excess Temperature Spindle
•
O v e r v o l t a g e t r i p Mains voltage too high
•
U n d r v o l t a g e t r i p Mains voltage too low
•
U n d e r v o l t . s t o p Mains voltage too low
•
P w r s t a g e o f f ! output stage switched off
•
E m g c y s t p a c t i v e Emergency input engaged
•
N o s p i n d l e ! Without spindle or cable defect
•
R S 2 3 2 E r r o r ! Timeout serial interface
•
D i a g r a m E r r o r ! Invalid characteristic
•
EncoderError ! Error with speed sensor / hall sensor
•
B a c k e n g y t r i p Error Power Stage switch off because of
deceleration ramp to high
•
G N D f a u l t ! Error PE is connected with a spindle line or
converter is defective
7.5 Adjustment or rotational speed
The preset of the rotational speed can be achieved by two ways:
•
manually preset with menu keys
For this, the Option-Button 0 in the line Duty speed in the grey field in the menu "
Analogue-
Inputs
" of SFU Terminal Software has to be activated. By this all analogue inputs were switched
to inactive and no analogue signal is selected for Start.
The duty value for rotational speed is displayed at the LCD-Display and can be adjusted with the
rotary encoder. The speed of change is dependent on the speed of dialing. The rotational speed
can altered during operation, also.
•
preselection with a voltage applied to the analogue input SetValue Rotational speed
For this, an analogue input has to be assigned to this function, which can be done in SFU
Terminal Software in the menu "
Analogue-Inputs
". Additionally it has to be selected a scaling for
the analogue voltage in the listbox field at left. 3 scalings are possible: 1V/10.000rpm or
1V/1.000rpm or 0-10V min/max).
The value of the rotational speed according the scaling is displayed on the LCD-display and can
be altered as wanted.
An input voltage of 0V leads to Standstill and a voltage > min voltage will make the spindle start
up to the speed according to the current scaling.
A scaling 1V/10.000 and a voltage of 4V will cause a speed of 40.000 rpm.
All settings made in SFU-Terminal have to downloaded into the SFU before they are valid with
the button Write only I/O (F6) .