![background image](http://html.mh-extra.com/html/bmpro/drifter/drifter_owners-manual_2779845017.webp)
17
WATER TANK LEVEL WIRING
1. Empty the water from the tank(s)
2. Choose a suitable side of the tank where the level-sensing bungs can be located.
3. Drill the required holes as shown in Figure 5.
4. Fit the four bungs to the holes as detailed in Figure 6. Pay particular attention to which
bung goes into which hole, matching the wire colours as shown in Figure 6.
5. Connect the pump and remote on/off switch as detailed in Error: Reference source not
found (assuming Setec power supply is used). If used with other power supplies, connect
according to Error: Reference source not found.
6. Connect the water-tank sensors as detailed in Error: Reference source not found.
7. Fill the tank(s) and check for water leaks around the bungs. Reseal as necessary.
8. Test operation of water level sensors, water pump switch, and remote on/off switch.
20
Drill Holes:
Ensure Water Tank is empty before proceeding.
Drill four (4) Ø10mm holes in Water Tank.
The bottom bung is to be located as close as practical to
the bottom of the tank.
The Top bung is to be located at desired height for 'Tank Full'
Indication, recommended height is ¾ full depth
Ø10mm
(x4 places)
4
1
2
3
100
– 12
0
Rec
omm
end
ed
Equal
Equal
Equal
Water Tank
Figure 5
20
Drill Holes:
Ensure Water Tank is empty before proceeding.
Drill four (4) Ø10mm holes in Water Tank.
The bottom bung is to be located as close as practical to
the bottom of the tank.
The Top bung is to be located at desired height for 'Tank Full'
Indication, recommended height is ¾ full depth
Ø10mm
(x4 places)
4
1
2
3
100
– 12
0
Rec
omm
end
ed
Equal
Equal
Equal
Water Tank