![background image](http://html.mh-extra.com/html/bmpro/drifter/drifter_owners-manual_2779845014.webp)
14
INSTALLING THE DRIFTER
PERSONNEL
Installation is to be carried out only by suitably qualified personnel.
INSTALLATION ENVIRONMENT
The Drifter should be located indoors where it will not be subject to water or other liquid spills
or splashes.
In addition, for the temperature display to be usefully accurate, the Drifter should be located
where it will not be subject to hot or cold drafts, e.g. above a kettle is an undesirable location
from both a moisture and temperature perspective.
MOUNTING
The Drifter is supplied with a mounting bracket for attaching to the wall.
› Mounting screws should not be proud of the bracket by more than 1.8mm in order to
allow the Drifter to fit on the bracket.
› The access hole to the wall cavity must be similarly sized to that in the bracket to provide
clearance for the connectors at the back of the Drifter.
› See Figure 1 for details.
When wiring is completed and the connectors are mated to the unit, fit the Drifter as detailed in
Figure 2.
If it is ever necessary to remove the Drifter from its mounting bracket, follow the instructions in
Figure 3.
16
Figure 1: Mounting Bracket Details
80 mm
42
mm
47 mm
5.2 mm
1.8 mm
MAX
Screw head clearance
for mounting screws
Figure 2: Fitting Drifter onto mounting bracket
Locate the Drifter over the four
bracket tangs, then push down
until dimple 'A' locks in hole 'B'.
A
B
Figure 3: Removing Drifter from mounting bracket
Insert flat-blade screwdriver into slot 'A'.
Gently lever case away from bracket
enough for dimples 'B' to clear locating
holes Then slide Drifter upwards.
Note: Some force may be needed to slide
the Drifter upwards because it usually
binds tightly on the four locating tangs.
B
A
B
Figure 1: Mounting Bracket Details