Blunik Trip II PLUS, Manual

Page: 42 / 61

BLUNIK II PLUS INSTRUCTIONS
· 41 ·
Right side of the screen. START in STAGE.
Function performed by pressing when we
use it with BLUNIK Active
Disabled – Function deactivated.
Next Sta – Next stage – Keep Clock.
Next S 0 – Next Stage – Clock starts from Zero.
When dealing with IMPOSED MEASURES or TABLES type stages.
In the event of the START in STAGE function being enabled this key directly
activates the next stage. The option for the clock not to be reset to zero can
be chosen.
When dealing with sections in
LEARN mode or COPY mode.
Doesn’t change stage. Changes mode.
If it is in LEARN, goes to COPY.
If it is already in COPY returns to COPY with the same database.
This is very useful for regularity tests on circuits.
+info: LEARN/COPY MODE — page:049
Note: The START in STAGE function is always deactivated on turning the BLUNIK II on so as to avoid
possible errors in subsequent rallies. The function of activating External Reference measure changes
is always activated.
6.17. PRECISION ADJUSTMENTS
When we are in a Timed section it is important to regulate the precision of
the BLUE light well.
If we leave a very wide margin we are going to be penalised a few points despite
having the Blue light the whole time. If we put it too low, the requirements
will rise and perhaps we will spend the whole stage in Green or Red without
being able to maintain the Blue.
The offset can be used in Rallies where the tenths are rounded off, leaving
only the seconds.
The corrections to
+-10 mts can be good for some rallies, but for others
+-2mts may be better.
START BUTTON