Blunik Trip II PLUS, Manual

Page: 27 / 61

· 26·
We have to confirm by pressing
The counting mode different from Normal appears
on the screen in place of the sensors:
R for
REVERSE COUNT and N for NOT COUNT . If we
have ACOUSTIC DRIVE this will also remind us
acoustically.
5.5.3. Verifications
By pressing we can enter the stage programming to verify the actual Start
Time that BLUNIK is using in this stage.
We can also verify the averages and distances programmed. Any value that we
vary will be taken into account by BLUNIK and recalculated from
the beginning of the stage. We exit by pressing
The start time registered in the BLUNIK is what determines the calculation of the
theoretical distance.
By pressing we can verify or reprogram our Parameters. Any value that
we change will be taken into account only from that moment. We exit by
pressing
5.5.4. Compensations
Circumstances can occur that can vary our measurements. This can be due
to temperature differences, tyre wear, different route, etc.
If we detect systematic measurement differences, we can compensate for
them in various ways.
WE CAN USE THE ADJUSTMENTS SCREEN
For example: the temperature has dropped a lot.
Our wheel has got smaller. We have to reduce the
calibre.
We adjust Calib Adj to -1.0m/km (for example).
This calibration modification will only be valid during this sector.
ADJUSTMENTS
COUNTING MODE
COUNTING MODE
COUNTING MODE