BLUM MINIPRESS M, Manual, Page: 6 / 28

6 BA-100/1EN M52.XXXX
The machine complies with the current safety standards. However, risks remain for:
• The operator and second persons due to the stroke movement of the drilling unit and especially in cases where safety devices are
removed or control elements should fail.
• Other remaining risks are indicated by the safety decals and in the following safety rules. It is therefore absolutely essential to follow
all safety instructions carefully.
D.1- Remaining risks according to ISO EN 12100-2
D - Safety information
D.2 - Safety decals
D.3 - Intended use
D.4 - Safety information
• The designated purpose of the assembly machine is the drilling and insertion of furniture fittings into work pieces made of wood,
particle board or plastic coated wood. The assembly machine should only be used in manufacturing. The manufacturer does not
assume liability for uses not described in the instruction manual.
• The machine is not explosion-proof. It should not be set up near a paint finishing system
• Disconnect the assembly machine from the power supply before retooling or performing any work on drill bits.
• Only use sharp, clean drill bits.
• Particular care must be taken when working on sections that jut out over the worktable. Attach a larger work table or use extensi-
ons.
• Secure the work piece during drilling/insertion. Use suitable clamping equipment.
Completely read the operating instructions and the safety information before operating the assembly machine
Wear proper eye and face protection when operating this machine
Only one person at a time should operate the machine
Electrical connections and maintenance should only be performed by a qualified electrician.
Disconnect the assembly machine from the power supply before making any repairs. (eg un plug)
Keep hands away from the drill or swing arm during the drilling or insertion process.
Do not remove safety devices - danger of injury.
Keep hands away from the danger zone. - danger of being crushed