BLUM MINIPRESS M, Manual, Page: 22 / 28

22 BA-100/1EN M52.XXXX
6.3 - Function errors
6 - Troubleshooting
Error Cause Solution Comment
Motor does not run Assembly machine is not connected to
the power supply Connect assembly machine to the power
supply none
Building fuse has failed Reset fuse or replace none
Swing arm is swivelled down Swivel up swing arm See point 2.1.12
Check mains voltage and compare with
motor data. Have checked by authorised
electrician Assembly machine connected to the
wrong voltage See electrical dia-
gram
Motor defective Have motor replaced by an authorised
electrician none
Motor overheats Assembly machine connected to the
wrong voltage Check mains voltage and compare with
motor data. Have checked by authorised
electrician See electrical dia-
gram
Drilling in hard wood with too high a
speed Pull handle down slower none
Motor hood is dirty or covered by some-
thing Remove objects and chips in the area of the
motor hood none
Gearbox defective Support, spindles or gears are damaged Replace gearbox none