BLUM MINIPRESS M, Manual, Page: 16 / 28

16 BA-100/1EN M52.XXXX
3.1 - Cruciform mounting plate assembly
3 - Assembly
3.1.1) Required parts
• Drill bits:
1 x ø5 mm clockwise
(3.1) (marked in black)
1 x ø5 mm counterclockwise (3.2) (marked in red)
• Cover caps (2.3)
• Carcase side
• Cruciform mounting plate with system screws
3.1.2) Setting drill bit length (see point 2.1.2)
3.1.3) Setting drilling pattern
• Pull sprung loaded knob out (2.5) .
• At the same time, move the lever (2.6) to the “Hole group” symbol (3.3)
• Release knob back to original position (2.5) .
3.1.4) Installing drill bits into the chuck
(see point 2.1.4)
3.1.5) Checking drilling depth setting
(see points 2.1.5 / 2.1.6)
3.1.6) Setting the stop system (1.4)
• Loosen the clamping lever (2.15) .
• Remove locking pin (2.16) and set gauge (1.4) to SY.
• Secure the clamping lever (2.15) .
This fixed setting provides a drilling distance of 37 mm.
3.1.7) Placing carcase side on the work table and pushing up against the stop
(See point 2.1.9)
3.1.8) Drilling
(See point 2.1.12)
˜ ˜
L