BLUM MINIPRESS M, Manual, Page: 21 / 28

21 BA-100/1EN M52.XXXX
6.2 - Fitting insertion error
6 - Troubleshooting
Error Cause Solution Comment
Fittings cannot be
inserted or only with
great difficulty Insertion ram or swing arm is driving
against an object (e.g. swivel stop)
The surface of the work piece is too hard
Drillings are not deep enough
The drilling diameters are too small
Remove object
Bevel drillings
See point “Drilling depth not reached”
Check drill bits and replace if necessary
none
Use slip-on counter-
sink
none
none
The insertion ram has shifted or turned
Drill chips are in the drill holes
Swing arm is not set properly
Set insertion ram
Remove chips from drillings
Check swing arm setting
See point 2.1.10
none
See point 2.1.13