BLUM MINIPRESS M, Manual, Page: 11 / 28

11 BA-100/1EN M52.XXXX
1 - Assembly machine setup
1.3 - Electrical connection
1.3.1) Electrical connection
• The assembly machine comes with a connector. If this is not suitable, an adapter
must be used.
Important:
The assembly machine is designed for the voltage printed on the label
of the connection cable.
For use with other assembly machine operating voltages, see Chapter
8 - Diagrams
1.4 - Dust extraction
1.4.1) Connecting extraction system to the assembly machine
ATTENTION:
The machine must be connected to a dust extraction system!
• Insert the spiral hose with an inside diameter of 80 mm into the receiving tube and fix
it.
• Make sure that the average air velocity for the extraction system is at least 20 m/sec.
• If there is no extraction system connector with a diameter of 80 mm, the supplied
adapter (image 1.4.2) can be used. For connection, make sure that a minimum air
velocity of 20 m/sec is provided at the cross-section of the 80 mm hose.
1.1.5) Attaching work table
a) Accessory work table reference MZA.5200
• Set work table on runner plate
• Attach work table to runner plate
b) Above table is not supplied with machine unless ordered seperately. For details of
how to construct a work table, see Chapter 7 - Appendix
1.1.4) Attaching swivel stops (optional)
• Loosen clamping screw until the location plate protrudes 10 mm
• Attach swivel stop to ruler at an angle and stand upright
• Tighten clamping screw
Note:
This procedure can also be used to set a stop between two available
stops.
XXX V / XX HZ
mwttttt mmmmtm tmttt ttt tmttttttmt mttt mwttttt mmm
mwttttt
mwtttttmm mmtm tmttt ttt tmttttttmt mtt
mwttttt mmm
mwtt tttmmhb nhnhn hhnh nmmtm tmttt ttt tmtttlkl kll lkkltttmt mttt
mwttttt mmhb nhnhn hhnh nmmtm tmttt ttt tmtttlkl kll lkkltttmt mttt
mwttttt mmm
mwttttt mmhb nhnhn hhnh nmmtm tmttt ttt tmtttlkl kll lkkltttmt mttt
mwttt ttmmm
mwttttt mmhb nhnhn hhnh nmmtm tmttt ttt tmtttlkl kll lkkltttmt mttt
mwttttt mmhb nhnhn hhnh nmmtm tmttt ttt tmtttlkl kll lkkltttmt mttt
mwttttt
mwt
mwt
mwt
mwt
mwt
mwt
mwt
mwt
mwt
mwt
mwt
mwt
mwt
mwt
mwt
mw
mwt
mwt
mwt
mw mw
mw
mw
mw
mw
mw
mw
mw
mw
mw
mw
mw
mw
mw
mw
!
1.
2.
3.
!