8
SETUP INSTRUCTIONS
Before assembling your product, please take a few minutes to check the contents and become
familiar with all the parts.
WARNING!
DO NOT
overfill the pool or allow people to lay over or sit on the pool walls.
DOING SO CAN CAUSE PERMANENT & SEVERE INJURY!
DRAIN your pool to the proper level after a heavy rain.
TIP:
It will be much easier to install your pool if you unfold it and let it lay in direct sunlight for about
2 hours prior to installation. This will help to ensure a wrinkle-free fit because the pool material will
be more pliable allowing it to form into shape during installation.
IMPORTANT:
The pool must be assembled on a smooth and level site of firm soil that is free of
stones, gravel, sticks, blacktop, or other oil-base compounds.
NOTE:
Before setting up your pool, it is recommended that you clear the area of hardy grasses.
Certain types of vigorous grasses such as St. Augustine and Bermuda can grow through the liner. A
ground cloth or tarp may be helpful in preventing this from occurring. Grass growing through the
liner is not covered under warranty.
WARNING:
DO NOT
install the pool on a wooden deck or any type of wooden surface. You cannot
use sand and/or uncompacted soil to provide a level surface for this pool; it will only wash out.
WARNING:
FAILURE TO FOLLOW ALL OF THESE INSTRUCTIONS WILL VOID THE WARRANTY!
Site Preparation
1.
Select a level area, and completely remove all debris, twigs, stones, etc. DO NOT select an area
under overhead electrical lines, trees, or within 15 feet of a house, building, etc.
2.
The pool shall be located a minimum distance of 6ft (1.83m) from any electrical receptacle.
3.
All 125 volt, 15 and 20 ampere receptacles located within 20ft (6.0m) of the pool shall be protected
by a ground fault circuit interrupter (GFCI). The 20ft (6m) distance is measured via the shortest
straight line distance the supply cord would follow without piercing a floor, wall, ceiling, doorway,
window, or other permanent barrier.
4.
Contact your local utilities, checking that no underground cables, telephone lines, gas lines, etc.
run beneath the area you have selected.
Setup Instructions
1.
Carefully unfold the Speed Set pool and inspect the seams for manufacturing defects. With the
inflatable ring on the top side, and safety writing on the outside, lay out the pool in the area
selected, making sure the bottom of the pool is both flat and round.
2.
If your pool included openings or you are going to purchase a filter pump system, position the
Suction & Return fitting locations so they are 10 to 21 feet from the electrical outlet you plan to use
for the pool pump.
3.
If your pool came with fittings, install both the Suction and Return fittings to the pool wall before
filling the pool.
4.
After installing the suction and return water fittings, connect the filter system following the
instructions in the manual that came with the filter system.
Inflation Instructions
CAUTION:
Inflate by adult only.
DO NOT
overinflate, use high pressure air compressor to inflate, or
exceed the recommended Design Working Pressure. Inflate with cold air only.
1.
Inflate the air chambers slowly following the numbered sequence (if any) with a manual air pump.
