![background image](http://html1.mh-extra.com/html/paradise-pools/fiji/fiji_assembly-manual_3583153001.webp)
1
Paradise Pools - Fiji
RECTANGLE POOL ASSEMBLY GUIDE
Prep Tips:
It is recommended to have an additional 18” of space on each side of
your pool.
For example: a 9’x17’(2.7mx5.2m) pool should have a space of at least
12’x20’(3.7m x6.2m)
It is important that your pool is set on a ground surface no more than 3”
out of level.
Make sure that all debris has been cleared from the spot where you will
set up your pool.
Setting Up Your Pool:
Step 1): Remove the liner from the carton marked “LINER”, and place it in the
center of the spot where you plan to set up your pool. Be careful not to
damage the liner when opening the box.
Step 2): Unfold the liner. Note where the pump and filter system will be
connected. Position the two circular openings marked “SUCTION” and
“RETURN” for easy connection to the pump and filter unit.
Step 3): Make sure the U-Pipe flaps that are welded on the bottom of the
liner, are pulled out from underneath the pool, so they are exposed around
the perimeter of the pool.
Step 4): Remove the framework from the cartons marked “FRAMEWORK”
and separate into four groups:
Top rails (larger diameter straight pipe)
Top corner rails (larger diameter, 90 degrees, 4 pieces)
Vertical Poles (smaller diameter, straight pipe)
U-Pipes (smaller diameter, with 90 degree bends at both ends of
pipe)
Please refer to the “PARTS LIST AND SPECS” page to check that
all parts are accounted for.
DO NOT DIVE INTO POOL