16
5. PROGRAMMING VARIABLE TIME & SPEED OPERATIONS
3.4) “DOWN” BUTTON:
• In Manual Mode, it can be used to decrease the pump speed.
• When used during Current Time programming, users can cycle down to the previous interface to
view the timing item page.
• When used in programming the Automatic Mode “T” segments, it is used to decrease the time or
speed in that segment.
• Pressing and holding will rapidly decrease the change in value.
3.5) “COMBINATION” BUTTON FUNCTIONS:
• Press the “UP” and “DOWN” buttons at the same time to switch between “Automatic mode” and
“Manual mode”.
• Press the “RUN/STOP” button and “Set” button at the same time and hold for 3 seconds to set the
current time. If you need to cancel the setting, press the “On / Off” button and “Set” button again to
exit.
6. MAINTENANCE/STORAGE & WINTERIZATION
MAINTENANCE
• Clean strainer basket regularly. Do NOT strike basket to clean. Inspect strainer cover gasket
regularly and replace as necessary.
• Pumps have self-lubricating motor bearings and shaft seals. No lubrication is necessary.
• Keep motor clean. Do NOT use water to hose off motor.
• Occasionally, shaft seals must be replaced, due to wear or damage. Replace with genuine seal
assembly kit.
STORAGE & WINTERIZATION
WARNING
Separation or Explosion Hazard.
• Do not purge the system with compressed air. Purging the system with
compressed air can cause components to explode, with risk of severe injury
or death to anyone nearby. Use only a low pressure (below 5 PSI), high volume
blower when air purging the pump, filter, or piping.
ATTENTION
Use
ONLY
propylene glycol as antifreeze in your pool/spa system. Propylene
glycol is nontoxic and will not damage plastic system components; other anti-
freezes are highly toxic and may damage plastic components in the system.
• Drain all water from pump and piping when expecting freezing temperatures
or when storing pump for a long time (see instructions below).
• Keep pump dry and covered during storage. To avoid condensation/corrosion
problems, do
NOT
cover or wrap pump with plastic film or bags.
Allowing the pump to freeze will void the warranty.
ATTENTION
