14
CONNECTING THE Baby b. TO AN ORGAN
1) Connect both AUDIO OUT jacks on the Baby b. with your amplifier using two (MONO) quarter
inch cables. If you not be sending a stereo signal, use just the LEFT/MONO output jack on the Baby
b.. For an optimal Rotor sound you should connect your Baby b. in stereo.
2) Connect the MIDI out jack on your organ with the MAIN-IN jack on the Baby b.. Use a standard
5-connector MIDI cable.
3) Normally your organ will have a volume pedal, bass pedal bank and foot switch built in. You can
use these controllers globally to control both the organ and the Baby b..
4) Connect the included power supply to the POWER-IN jack of the Baby b. and plug it into your
power source. Turn on the power switch on your Baby b. as well as your MIDI and amplifier
equipment. Play some keys on your MIDI keyboard to make sure the connetions are functional.
5) Normally your Baby b. uses MIDI channel 1 for the upper manual, MIDI channel 2 for the lower
manual, and MIDI channel 3 for the pedal bank. It could be necessary for you to change these channel
assignments in your Baby b.. See „EDIT Key/Global Parameters.“
NOTICE! The Baby b. has a special function to allow adapting to a keyboard. Using a program change
command the Baby b. can be turned on or off per channel. See the directions in the section „Receiving
Program Change Commands“ on page 38.
Summary of Contents for Baby b.
Page 56: ...56 MIXERMAP LOWER BASS MIXERMAP PROGRAM...
Page 57: ...57...