D
B
C
A
Filling the dishwasher salt
Important
Only use special dishwasher salt in your appliance.
The manufacturer is not liable for damage resulting from
the use of the wrong type of salt.
Do not use coarse-grained salt. Small grains or powdered
salt is more easily soluble. Never use culinary or table
salt. These types of salt do not dissolve in water easily
and will damage the softening device.
Remove the lower basket from the appliance.
Open the screw-in cap of the salt container by turning it
counter clockwise (fig. ).
When operating for the first time:
Pour 1 litre of water into the salt container (Fig. ).
Pour the salt into the container with the aid of the salt
funnel provided (Fig. ).
Pour in enough salt to
fill the container. The container holds approx. 2 kg.
Close the cap tightly.
Begin a washing program immediately after filling the salt
container. The washing program prevents damage to the
appliance which may be caused by any spilled salt solution.
After the first washing cycle, the salt level indicator light
will go out.
A B
C
D
Turn the
handle to
the right
A
B
25cm³
15cm³
5cm³
1
2
B
3
4
A
1
2
7
8
3
4
Filling the Rinse Aid Dispenser
Rinse aids allow washing water to rinse off more cleanly
and prevent watermarks or streaks on the dishes.
Only use rinse aid designed for use in dishwashers.
- Note -
If you use 2 in 1 or 3 in 1 detergents / tablets, you do
not need an additional rinse aid.
Open the rinse aid dispenser by pressing the locking
lever ( )
Carefully pour in rinse aid to the MAX mark.
Close the lid until it clicks ( ).
Carefully wipe off spilled rinse aid. Excessive rinse aid
causes excessive foam formation, which may hinder
cleaning.
Set the dose of rinse aid
The dose of rinse aid to be used can be set by means of
the dispenser regulator (between levels 1 and 6) ( ).
Your appliance is pre-set at the factory to level 3.
Only change the setting if the following applies after
washing:
Watermarks are visible on the dishes: Set dosage
higher
Streaks are visible on the dishes: Set dosage lower
Filling the Detergent Dispenser
- Note -
Only use detergents formulated for use in dishwashers.
Open the detergent container by pushing the locking
lever to the right ( ).
The lines on the inside of the detergent container will
help you measure the correct amount of detergent.
The detergent container holds a total of 40 cm³ of detergent
( ).
When the dishwasher is fully loaded and the dishes are
very dirty, we recommend filling the detergent container
up to the 25 cm³ mark. When the dishes are less dirty,
it is generally sufficient to fill the detergent up to the 15
cm³ mark.
If your dishes have been in the dishwasher for some time
without being washed, you should also fill the small
detergent container up to the line ( ).
The programme table shows the amounts of detergent
required for the different wash programmes.
These may differ according to how dirty the dishes are
and the water hardness in your location.
