![background image](http://html1.mh-extra.com/html/blomberg/1580l/1580l_operating-manual_2773867018.webp)
33
34
Possible Causes
- Improper loading
- Overloaded baskets
Possible Causes
- The dishes were pre-washed by
hand with a large amount of
detergent
- Rinse aid has accidentally leaked
into the appliance
- The cover of the rinse aid
dispenser was not closed.
Possible Causes
- Clogged strainers
- Drain hose bent. Relief hose
blocked or bent.
Load capacity
12
Permitted water pressure 0,3 10 bar (= 3 100 N/cm²
= 0,01-1,0Mpa)
Electrical connection
230 Volts, 10 Amps
(see type plate)
Output
2000 W
Heat output
1800 W
Because we continually strive to improve our products,
we may change our specifications and designs without
prior notice.
This device corresponds to the following EU directives:
73/23/EC
Low Voltage Directive
89/336/EC
EMV Directive
93/68/EC
CE Marking Directive
DIN EN 50242
Electrical dishwasher
for home use
Testing procedures for
practical service conditions
Safety notes for installation
Prior to installing and using your appliance, please check
it for possible transit damage.
If the appliance is damaged, please contact your supplier.
Never install or use a damaged appliance.
The following directions must be followed to connect the
dishwasher properly.
Before operating your dishwasher, please ensure that
the information on the type plate corresponds to the
current and voltage of your power supply.
The appliance may only be connected using a properly
grounded socket. Ensure that the appliance is grounded
according to regulations.
The grounded socket must be easily accessible and
close to the appliance.
Do not use extension cables or multiple adapters, as
this can lead to overheating, which can be a fire hazard.
Hardwiring may only be carried out by a qualified
electrician.
Check the power cable, the water inlet hose and the
drainage hose. Damaged parts may only be replaced
by customer service personnel or by a qualified
electrical service expert.
Foam
Water remains inside the
appliance after the rinse cycle
Dishes Break
Solutions
-
Load the dishwasher as suggested in the directions.
-
Do not overload the dish baskets. Dishes may knock against
each other and break.
Solutions
- Dishes do not need to be pre-washed. Heavy soiling may
be removed with a dishcloth or under running water.
- If rinse aid has been spilled during refilling, wipe up the
excess using a paper towel or sponge.
- Always take care to ensure that the lid is closed after refilling
the clear rinse aid dispenser.
Solutions
- Clean all strainers and filters as described in the manual
- Ensure that the relief hose is properly installed.
Technical Specifications
10
Directions for Assembly
11