103
INTRODUCTION
NAVIGATION
RADIO MODE
CD MODE
INDEX
SETUP
CD CHANGER
ENGLISH
DEUTSCH
DEUTSCH
DEUTSCH
7
Use the right knob/pushbutton
;
to select
START
.
8
Carry out the steps as instructed by the system.
Carrying out the system test
You have the option of carrying out a system test. The system checks the GPS
antenna and whether the reversing signal and the vehicle ignition are correctly
connected to the system.
1
Select
SYSTEM TEST
menu item in the
INSTALLATION
setup menu.
2
Press the right knob/pushbutton
;
.
3
Choose between
SENSOR TEST
,
INTERNAL
TEST
and
CALIBRAT. DATA
.
✔
The displays containing the corresponding test results are shown.
Activating / deactivating the code feature
You can activate your TravelPilot’s code feature in the
SAFETY
setup menu. If
the code feature is activated and the unit was disconnected from the battery
power supply, you can only operate the unit again once you have entered a
code number.
Note: Since the TravelPilot is not equipped with any other theft pro-
tection system, you should activate the code feature.
To activate / deactivate the code feature,
1
highlight the
CODE
menu item in the
SAFETY
setup menu and
2
press the right knob/pushbutton
;
.
The code feature is activated / deactivated. The current status is displayed along-
side
CODE
. You have to respond to the confirmation request by entering the
code. The default setting is
OFF
, i.e. the code is not activated.
SETTINGS
INSTALL
DEFAULT SET.
FM-SEEK
SENS
SAFETY
LANGUAGE
INSTALLATION
SYSTEM TEST
CALIBRATION
GPS STATUS
