Blastrac BMP-4000E, Operating Instructions Manual

Page: 15 / 41

15
4. Initial operation
Before using the machine it is of great importance to inspect the machine every day.
It is not permitted to use the machine if the machine safety is not according the checkpoints below.
4.1 Checkpoints of electrical safety (E-version)

Use only extension cables for extending the main cable that are sized and marked in accordance with
the overall power consumption of the machine.

Any damage to electric cables is not permitted and they must be rolled entirely off of the reels.

Check the cable and plug of the dust collector.

The main power switch on the machine must be in the “Off” position before connecting to the power
supply.

Always use an electrical power supply connection with earth connection.
4.1 Checkpoints of Diesel engine safety (G-version)

Make sure the location is adequately ventilated.

Make sure There is a sufficient amount of fuel in the fuel tank.

There is a sufficient amount of engine oil in the engine.

Make sure No persons are located in the danger zone of the engine or machine.

All safety equipment is in place.
4.2 Checkpoints of machine safety
Check if:

All hydraulic hose connections are tightened and there is no leakage of oil.

The safety functions and operating functions work correct.

The drum with picks is in good condition and the picks can turn free in the drum.

The rubber seals around the drum housing are not damaged.

There are not any loose nuts or bolts.

There is not any damage to the dust hose and if it is connected correctly with a hoseclamp and
industrial tape.
Work area

Check the surface to be treated for loose parts (stones, screws, etc.) The surface must be swept if
necessary. Make sure the machine can travel over all inequalities on the surface. Small inequalities like
weld seams or floor joints are no barriers for the machine.

Secure the work area around the machine providing an adequate safety distance from the machine.
Use a red and white safety chain and danger sign to enclose the work area.

Remove reinforcing steel or other objects protruding from the surface in order to prevent damage to
the machine.

Warning! Make sure that the surface to be treated does not contain dangerous materials
such as: - combustible or explosive dusts or substances.
- carcinogenic or pathogenic substances.