Operating Instructions Manual BMG-2500 MULTI GRINDER
31
JANUARY 2005
© International Surface Preparation Group, Inc.
10.8
Keeping machine clean
10.8.1
After daily use, disconnect the machine from the dust collector and the power source. Tilt the
machine back by following the instructions in section 10.6.2.
Follow all safety procedures mentioned in Section 4.0 and throughout this manual when cleaning
machine.
Clean the undercarriage with a vacuum and brush, or a water hose fitted with a nozzle. Do not let cement
or coating dust build-up in the machine as this could create interference with the movement of the tool
holders and overload the machine. Make sure that the exhaust ports and hoses used for dust collection
are clean as well.
Keep these areas free
from caking dust and
debris
Figure 18 – Clean-out area for vacuum port
10.8.2
Clean off all grease fittings and all grease residues.
10.8.3
During the cleaning of the machine, inspect all components for wear and tear. If you find worn
parts, replace them with original Blastrac
®
parts. Check the bolts on the Morflex
®
couplings and
the bolts and nuts used to hold the holder blocks and cutters in place. Inspect the diamond holder
arms for cracks or other damage.
10.9
Transporting Machine - Secure machine by setting the tool area on a piece of plywood or
cardboard and strap down machine to a shipping pallet, trailer bed, etc. in the normal upright
position. Securing the machine with straps reduces the risk of bouncing the machine and
damaging the tools and tool holders.
