12
PALIOS-IPM2
Part N
o
: 5105.01
8 pole IP-/ ASI-TV Modulator
IP/ SFP/ ASI (MPEG2)
→
ATV (8x AM)
SBL
The following parameters are adjustable:
Program list (Transponder)
If “Program selection with select box“ in chapter “GUI settings“ is deactivated
(see also chapter 7.2.6), the form at the left appears for program selection. All
programs of the selected transponder are listed with name and service ID. The
selection of the program is done by marking of the respective select box. The
program name and the other parameters of the program are adopted automatical-
ly. In this case the program name in the menu “Selected program“, variant 1 is not
selectable.
Input
input parameters of the channel
Input name
e.g. name of the program, editable
Input
sel.: IP input channels 1 ... 8, ASI TS
By pressing the “?“ button, the channel list is updated.
Selected program
variant 1: program selection menu
Program name
selection of the program from the program list of
the transponder of the selected IP TS
Service ID
displays the service ID of the selected program
Type
displays the type of the program
Language
selection of the available language
Direct input
selection: selection menu, direct input (see be-
low)
Selected program
variant 2: direct input
Program name
displays the name of the program, which was
selected in the input menu
Service ID
input of the service ID of the requested program,
adjustment range: 0...65535
Type
selection of the program type: TV, Radio
Language
input of the language n
o
, adj. range: 0..255
Output
output parameters of the channel
Frequency input
selection: channel, frequency
*
Output frequency
selection from channel table/ input in kHz
*
Output level offset
display of the level offset
**
RF signal
selection: On, Off
Sound deviation
selection: 30, 50 kHz
***
Sound carrier 2
selection: On, Off
*
If at the frequency input “channel“ is selected, the output frequency can be chosen in the
pre-selected channel spacing (see chapter 7.2.6). If, however, “frequency“ is selected, then
the output frequency is selectable in kHz steps.
**
Adjustment of the offset of each channel to the basic level, see chapter 7.2.6
***
Only selectable, if sound carrier 2 is set to “Off“. If sound carrier 2 is set to “On“, the sound
deviation is permanently 30 kHz
