Software Installation
21
The Take button illuminates red in the lower right corner
Number of Macros
If you want to make multiple crosspoint routing changes simultaneously, you can enable macro buttons so
that a single button press will change up to 16 crosspoint routes. Slide the "Number of Macros" slider to
enable up to 10 macro buttons. As you increase the number of macro buttons, there will be a corresponding
decrease in the number of available source buttons.
Click a green macro button to reveal the corresponding Macro window and then enter up to 16 pairs of
sources and destinations. When finished, click the
OK
button to save the routes and close the window.
Take Button
When the “Use Take Button” is enabled, the lower right button becomes red-colored. Use this configuration
if you wish to be able to select a change of route and then confirm the change by pressing the red
“Take” button.
The take button can be used with both Cut-Bus and XY controller configurations and can also be used with
macros.
When the take button is enabled, it replaces whatever source, destination or macro button had previously
been configured in the same button location.
Backlight
Adjust the backlight slider to vary the brightness of the backlit buttons as desired.
Enable the “Backlight Destinations Only” button if you wish to disable the backlighting of the white
source buttons.
Up to 16 crosspoint routes can be changed by a single macro.
Videohub Smart Control Settings in Blackmagic Videohub
Control Utility.
