Blackmagicdesign teranex mini, Installation And Operation Manual

Page: 49 / 657

7 SDI In C
The ‘SDI In C’ BNC connector is used to plug in quad link HD-SDI Ultra HD channel C.
8 SDI In D
Use this BNC connector to plug in quad link HD-SDI
Ultra HD channel D.
9 Ethernet PoE+
The Ethernet connector lets you plug your Teranex Mini into a network switch or
computer so you can change settings using Blackmagic Teranex Setup.The Ethernet
port also supports power over Ethernet plus.
10 SDI Outputs
These two BNC connectors let you output two separate 12G-SDI signals.
Switches
The switch 6 ‘on/off’ setting lets you change the 3G-SDI output standard to maintain
compatibility with equipment that can only receive level A or level B 3G-SDI video. Level B is
the default setting, and is accessed by setting switch 6 to ‘off’. To output Level A video, set
switch 6 to ‘on.’ These settings only apply when outputting 3G-SDI video.
The switch legend on the base of your
converter gives you all the information
you need to change conversion settings.
Blackmagic Teranex Setup Settings
The Teranex setup utility can change all the same settings that are available using the switches,
plus additional settings. You can access these settings by moving between the ‘video,’
‘configure,’ and ‘about’ tabs.
The ‘about’ and ‘configure’ tabs are detailed in the ‘changing settings’ section in this manual.
The ‘video’ tab for Teranex Mini - SDI to Analog 12G contains the following settings.
Video Processing Menu
‚ 3G Output
This lets you change the 3G-SDI output standard to maintain compatibility with
equipment that can only receive level A or level B 3G-SDI video. Level B is the default
setting. These settings only apply when outputting 3G-SDI video.
49 49 Teranex Mini - Quad SDI to 12G-SDI