BLACKBERRY RADAR R2 ITE100-1 INSTALLATION GUIDE
DRY VAN, INSULATED TRAILERS (BARN DOORS)—CARGO PERCENTAGE
6
Fastener Considerations—User-Supplied Fasteners
To attach the module to the asset you wish to track, you must supply your own fasteners.
Depending on the construction of your mounting location, you may wish to use the following
types of fasteners. Please Note: Your choice of fastener will influence the size of the tools
required to create the mounting holes (i.e., drill bits) and install or remove the fasteners (i.e.,
wrenches/sockets/drivers). An example of this is provided below. The actual length of the
fasteners will be determined by the thickness of your mounting surface.
IMPORTANT:
The maximum fastener thread diameter
supported by this product is ¼” or M6 (6 mm).
For most secure fastening, we do not recommend using fasteners
with a diameter less than that of a ¼” or M6 fastener.
Box Section
(+3mm wall thickness)
A) 2 thread rolling or B) 2 self-tapping screws
screws and washers
(3/8” head, 1/4”-20 thread, (3/8” head, 1/4”-14 thread,
1” length) 1-1/4" length)
*For installation in narrow clearance areas,
blunt-ended screws--like thread rolling screws--are recommended.
Drill Bit
A) 7/32” (6mm)
B) 3/16” (5mm)
Nut Driver/Socket/Wrench
Panel Section
(with rear access)
A) 2 thread cutting screws or B) 2 hex screws, Nylock Nuts,
Nylock Nuts, washers, sealing washers, and washers
and sealing washers.
(3/8” head, 1/4”-20 thread, (7/16” head, 1/4”-20 thread,
1-1/4" length. 1/4”-20 nut) 1-1/4" length. 1/4”-20 nut)
*For exterior door frame
installations, the use of Sealing Washers or Polyurethane Sealant is
recommended.
Drill Bit
A) 7/32” (6mm)
B) 1/4” (6 mm)
Nut Driver/Socket/Wrench
Panel Walls
(wood/composite core)
2 wood screws and washers
(#10 wood screw, Phillips PH2 Head, 1” length)
(5.0mm wood screw, Phillips PH2 Head, 25 mm length)
Drill Bit
1/8” (3mm)
Screwdriver
Insulated Trailer Wall
2 hex bolts, washers, and well nuts
Bolt: 7/16” head, 1/4”-20 thread, 1-1/2” length
Well Nut Insert: 1/4”-20 thread
Drill Bit
1/2” (13mm)
Nut Driver/Socket/Wrench
Accessory Adhesive Kits
For installations where drilling is not desired.
Available from your BlackBerry Representative.
NOTE: Not for use on bare wood surfaces.
Not for use with the Radar R2 Visor Accessory.
A) 7/32” (6mm)
B) 3/16” (5mm)
