User Manual 3D-Printer
Version 2018-3.1_ENG
41
8.2
Possible failure mode
Problem
Possible cause
Action / solution
3D printed part detaches from the belt
Too fast belt wall
or belt
Temperature too
low
Enable the feature
“
Belt Wall
”
In BLACKBELT Cura
and set it between 10 and 15 mm/s.
Slice the part and see the result in Layer View option
“
Feedrate
”
. The slos wall will turn blue.
Increase the temperature of the heated bed (Control
-> Temperature -> Bed)
3D printed parts adheres too strong to the
belt
Temperature
too high or
“
Belt
wall
”
too slow
Lower the temperature of the heated bed:
(Control -> Temperature -> Bed)
Disable the feature
“
Belt Wall
”
in BLACKBELT Cura
3D printed parts leaves marks on the belt Belt Offset too
small
Increase the belt offset
(set between 0.3 and 1mm in BLACKBELT Cura)
Bad surface quality of the print
Not enough
cooling
Make sure, the part cooling fan is mounted and
connected to the print head.
Increase the speed of the cooling fan
(Control -> Temperature -> Fan speed) during a print.
Or in BLACKBELT Cura, setting
“
Fan Speed
”
.
Conveyor belt is running curling against the
wall
Belt Calibration
needed
The belt needs to be calibrated (chapter 5.6)
One side prints closer to the belt than the
other side
Y calibration
needed
The Y axis needs to be calibrated (chapter 5.5)
8.3
Spare parts
Only original spare parts and machine parts of BlackBelt 3D BV can be used in the machine.
All consumer and spare parts can be found in the web shop of Blackbelt-3d.com or by direct inquiries at
. When sending inquiries always remark the number of parts and specifications.
In the following sub chapters we will explain some of the handling steps of replacing the most common spare parts.