User Manual 3D-Printer
Version 2018-3.1_ENG
16
6.
If you start noticing a resistant at one side, move the printhead to the opposite side.
7.
Loosen the following 3 screws for ½ rotation at one side of your choice, using the 5mm Hexagon key:
8.
Adjust the set screw to level the gantry - clockwise if the printhead is now at the same side, or
counterclockwise, if the printhead is now at the other side.
[5-6]
9.
Tighten the 3 screws again
10.
Check calibration as described in step 5 and 6
11.
Repeat step 5-9, until both sides have the same distance to the belt on both sides.
Set screw
3
4
5
6