RYAN 61 -
Item code: BH73
.
Instruction Manual
24
5) When you are sure that everything is a
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
slot in the mounting platform and to the verti-
cal stabilizer mounting area. Apply epoxy to
the lower rudder hinge. Set the stabilizer in
place and re-align. Double check all of your
measurements once more before the epoxy
cures. Remove any excess epoxy using a
paper towel and rubbing alcohol and hold the
stabilizer in place with T-pins or masking tape.
Allow the epoxy to fully cure before proceed-
ing.
Epoxy glue
C/A glue
Cut
Epoxy glue
R e m o v e
covering
Mark line
Summary of Contents for BH73
Page 10: ...RYAN 61 Item code BH73 Instruction Manual 10 Mark point Secure cut Mark point Secure...
Page 14: ...RYAN 61 Item code BH73 Instruction Manual 14 C A glue 4 x 12mm Secure Epoxy glue C A glue...
Page 15: ...RYAN 61 Item code BH73 INSTRUCTION MANUAL 15 Secure 3 x 12mm Cut Tie wrap...
Page 30: ...RYAN 61 Item code BH73 Instruction Manual 30 Rudder pushrod Elevator pushrod Elevator pushrod...
