RYAN 61 -
Item code: BH73.
INSTRUCTION MANUAL
19
4 x 30mm
Secure
Pushrod wire
Right side.
1. Slide the fiberglass cowl over the en-
gine and line up the back edge of the cowl with
the marks you made on the fuselage.
COWLING.
2. While keeping the back edge of the
cowl flush with the marks, align the front of
the cowl with the crankshaft of the engine. The
front of the cowl should be positioned so the
crankshaft is in
nearly
the middle of the cowl
opening. Hold the cowl firmly in place using
pieces of masking tape.
4. Install the muffler and muffler extension
onto the engine and make the cutout in the
cowl for muffler clearance. Connect the fuel
and pressure lines to the carburetor, muffler
and fuel filler valve.
3.
Slide the cowl back over the engine
and secure it in place using four wood screws.
See picture below.
Summary of Contents for BH73
Page 10: ...RYAN 61 Item code BH73 Instruction Manual 10 Mark point Secure cut Mark point Secure...
Page 14: ...RYAN 61 Item code BH73 Instruction Manual 14 C A glue 4 x 12mm Secure Epoxy glue C A glue...
Page 15: ...RYAN 61 Item code BH73 INSTRUCTION MANUAL 15 Secure 3 x 12mm Cut Tie wrap...
Page 30: ...RYAN 61 Item code BH73 Instruction Manual 30 Rudder pushrod Elevator pushrod Elevator pushrod...
