RYAN 61 -
Item code: BH73
.
Instruction Manual
18
Do not secure the tank into place perma-
nently until after balancing the airplane.
You may need to remove the tank to mount
the battery in the fuel tank compartment.
Fuel tank
Fuel tank tray.
C/A glue
Locate the long piece of wire used for the
throttle pushrod. One end of the wire has been
pre-bend in to a “Z” bend at the factory. This
“Z” bend should be inserted into the throttle
arm of the engine when the engine is fitted onto
the engine mount. Fit the engine to the engine
mount using the screws provided.
INSTALLING THE ENGINE.
120mm
Mark point
Drill a hole
6mm diameter.
Summary of Contents for BH73
Page 10: ...RYAN 61 Item code BH73 Instruction Manual 10 Mark point Secure cut Mark point Secure...
Page 14: ...RYAN 61 Item code BH73 Instruction Manual 14 C A glue 4 x 12mm Secure Epoxy glue C A glue...
Page 15: ...RYAN 61 Item code BH73 INSTRUCTION MANUAL 15 Secure 3 x 12mm Cut Tie wrap...
Page 30: ...RYAN 61 Item code BH73 Instruction Manual 30 Rudder pushrod Elevator pushrod Elevator pushrod...