EDGE 540-V3 30cc Item code: BH94
.
Instruction Manual
6
1. INSTALLING THE STOPPER ASSEMBLY
III. FUEL TANK
Drill a hole
6.2 mm diameter
Front view
1)
The stopper has been pre-assembled at
the factory.
2)
Using a modeling knife, cut one length of
silicon fuel line (the length of silicon fuel line is
calculated by how the weighted clunk should rest
about 8mm away from the rear of the tank and
move freely inside the tank). Connect one end of
the line to the weighted clunk and the other end to
the nylon pick up tube in the stopper.
3)
Carefully bend the second nylon tube up at
a 45 degree angle (using a cigarette lighter). This
tube will be the vent tube to the muffler.
4)
Carefully bend the third nylon tube down at
a 45 degree angle (using a cigarette lighter). This
tube will be vent tube to the fueling valve.
When the stopper assembly is installed in the tank,
the top of the vent tube should rest just below the
top surface of the tank. It should not touch the top
of the tank.
Secure
5 x 70mm
O.S GT-33CC
See pictures below:
II. INSTALLING THE ENGINE MOUNT
2.Secure
After both linkages are completed. connect both
of the aileron servo loads using a Y-harness you
have purchased.
1. Push in
4x12mm
Repeat the procedure to install the opposite
wing half
.
