EDGE 540-V3 30cc Item code: BH94
.
Instruction Manual
5
3)
Using the thread as a guide and using
masking tape, tape the servo lead to the end of
the thread: carefully pull the thread out. When
you have pulled the servo lead out, remove the
masking tape and the servo lead from the thread.
4)
Place the servo into the servo tray.
Center the servo within the tray and drill 2.5mm
pilot holes through the block of wood for each of
the four mounting screws provided with the servo.
Drill a hole
1.5mm
Secure
2x10mm
Secure
3. INSTALLING THE AILERON LINKAGES
3)
Repeat the procedure to install the
control horn on the opposite aileron.
1. A+B Epoxy glue
2. Push in
Aileron
control horn
Installing the aileron linkages as pictures below.
55mm
M2
lock nut
3x10mm
2. INSTALLING THE AILERON CONTROL HORN
1)
Remove the covering from the slot on the
bottom of the aileron.
2)
Insert the control horn into the slot and
secure it by A+B Epoxy glue.
5)
Repeat the procedure to install the
aileron servos in the opposite wing half
.
Aileron
control horn
Electric wire
