EDGE 540-V3 30cc Item code: BH94
.
Instruction Manual
15
1)
Cut out the switch hole using a modeling
knife. Use a 2mm drill bit and drill out the two
mounting holes through the fuselage side.
2)
Secure the switch in place using the two
machine screws provided with the radio system.
1)
Plug the servo leads and the switch lead
into the receiver. You may want to plug an aileron
extension into the receiver to make plugging in the
aileron servo lead easier when you are installing
the wing. Plug the battery pack lead into the switch.
2)
Wrap the receiver and battery pack in the
protective foam to protect them from vibration.
Use a rubber band or masking tape to hold the
foam in place.
3)
Position the battery pack and receiver behind
the fuel tank. Use two tie wraps to hold the battery
and receiver securely in place as pictures below.
Do not permanently secure the receiver and battery
until after balancing the model.
4)
Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver, for the
antenna to exit.
XIII. INSTALLING THE RECEIVER
AND BATTERY
Switch of engine
Battery of engine
Battery receiver
Receiver
Remove covering.
C/A glue.
XII. INSTALLING THE SWITCH
C/A Epoxy.
