48
8-PORT SERIAL PORT MANAGER WITH INTEGRAL MODEM
a) One character (default): When the one-character disconnect sequence is
selected, simply enter the selected logoff character once. (Default =
^X
([Ctrl] plus [X])
.)
NOTE
You don’t have to enter a carriage return before or after the logoff
character.
b) Three characters: Uses the format [
Enter
]
LLL
[
Enter
], where
L
is the
selected logoff character. For example, if the logoff character is defined as
+
, then the three-character disconnect sequence would be [
Enter
]
+++
[
Enter
].
If the default resident disconnect sequence is not compatible with your
application, redefine both the command format and logoff character via the
Port Configuration menus, as described in
Section 5.5
.
2. Third-party disconnect (Supervisor mode only): The /D command is issued
from your resident port to disconnect two third-party ports. For example, if
your resident port is port 1, a third-party disconnect is used to disconnect port
3 from port 4.
a) The /D command uses the format:
/D xx XX
[
Enter
], where
xx
and
XX
are the numbers of the ports that you want to disconnect.
b) The /D (Disconnect) command can only be invoked by a port with access
to supervisor-level commands.
c) The /D command specifies both connected ports, or either of the two
ports. For example, if port 1 is your resident port, use any of the following
commands to disconnect port 3 from port 4:
/D 3 4
[
Enter
]
or
/D 3
[
Enter
]
or
/D 4
[
Enter
]
Summary of Contents for SW544A-M
Page 3: ......