SERVSWITCH
™
BRAND CATX KVM EXTENDER FAMILY
36
Transferring DDC Information
This feature is only available on Remote Units with hardware version 6.3
or above. A version code number is printed on the base of each unit; the
hardware version number is the first two digits - see page 54).
To support non-standard screen settings or other features, it is possible to read and store DDC
information into the Local Unit directly from the monitors connected to the Remote Unit.
You only need to carry out this procedure once; the extender units store the DDC information
in non-volatile memory and restore it at power-up.
1.
Ensure that you have installed and powered up the system according to the instructions
in Section 3.
2.
Connect the monitor to the ‘monitor 1’ socket on the Remote Unit (see Figure 2).
3.
Enter Command mode (see page 28).
4.
Select the video channel to which you want to apply the DDC settings by pressing either
<1>,
<2> or <0>
(both channels).
5.
Press the key combination:
<Left Control> + <D>
6.
The DDC information is read from the monitor and applied to the selected video
channel(s) in the Local Unit. This may take a few seconds. The remote console keyboard
LEDs flash twice to indicate a successful transfer.
Always reboot Windows after adjusting a DDC parameter.
Summary of Contents for ServSwitch ACU2 01A-R2
Page 1: ...ACU2 01A ACU2222A R2 ACU2209A ACU2228A 2 R2 November 2009 ...
Page 2: ......
Page 60: ...NOTES ...
Page 61: ......
