INSTALLATION
23
3.4 Local Unit Installation
To install a Local Unit:
1.
It is recommended that the PC and other devices are switched off before connection.
2.
Using the supplied CPU KVM cable(s), connect the keyboard, monitor(s) and mouse
connectors on the computer (or KVM switch) to the corresponding connectors on the
Local Unit as shown in Figure 4.
Ensure that you attach the keyboard and mouse connectors to the correct ports. The
keyboard connector is purple; the mouse connector is green.
If your PC does not have a PS/2 mouse port, an active serial converter
will be required - Model No: AC244A.
3.
If you have a dual access system, connect the keyboard, mouse and monitor for the local
console to the appropriate ports on the Local Unit. The ports may also be used to feed
into a KVM switch.
4.
If you have an audio and serial enabled system, connect the audio cables between the
computer and Local Unit as follows:
Computer Local
Unit
Audio Out (green)
Audio In
Audio In/Microphone (pink/blue)
Audio Out
5.
If appropriate, connect the supplied serial cable between the serial port on the computer
and the Local Unit.
6.
Connect the CATx cables from the Remote Unit to the corresponding
INTERCONNECT ports (1&2) on the Local Unit (see Figure 5).
7.
Power up the PC.
The Local Unit normally takes power through the PC keyboard port.
In video only applications, this connection is not used and an external
power supply is required (PSU1006E-R3). Please contact Technical
Support for more details.
NEVER CONNECT THE REMOTE UNIT 9V POWER SUPPLY
TO A LOCAL UNIT: YOU MAY DAMAGE THE EXTENDER
SYSTEM.
Summary of Contents for ServSwitch ACU2 01A-R2
Page 1: ...ACU2 01A ACU2222A R2 ACU2209A ACU2228A 2 R2 November 2009 ...
Page 2: ......
Page 60: ...NOTES ...
Page 61: ......
