Page 13
724-746-5500 | blackbox.com
Chapter 4: Installation
4.2
Installing the Housing
1. Remove two panhead screws on top of front and back endcaps of the hous-
ing, then lift the top over the housing to its full span position.
2. From the outside, insert a cable strain relief plug into one of the two holes
located on the bottom rear of the housing. Screw a black nylon locknut onto
the cable strain relief plug from the inside of the housing and tighten. Repeat
for the other plug.
OPTION: Omit one or both cable strain relief plugs if
1
⁄
2
" metal conduit is used
in the cable entry holes.
4.3 Installing a Sony SNC-CS50 Camera (Not Included) into the Housing
1. To loosen the camera sled, turn the panhead screw located on the inside
ledge of the bottom half of the housing
1
⁄
2
turn counterclockwise. Slide the
camera sled toward the rear of the housing until the screw head is aligned
with the hole on the key slot of the camera sled. Lift and remove.
Sled screw
Camera sled
Figure 4-2. Removing the camera sled.
